Use your browser to connect to the router at

Change the IP address of your PC to the 192.168.1.0 subnet.

At this point, the initial dd-wrt image has been written to flash, the device has rebooted and is running.

Wait until the power LED turns to solid 'Yellow'.

When you see the message 'IMAGE UPLOAD SUCCESS', the flash will begin to be erased and re-written.

Browse to and upload the first image file, the 'factory' one.

The Emergency Room Updating Firmware screen should display. Hold the reset button for about 3~5 seconds, then release.

Press and HOLD the reset button on the router and connect power.

Open your web browser and get it ready to connect to 192.168.0.1.dir300-revb-ddwrt-webflash.bin (or the 600 equivalent, depending on whether you have the 300 or 600).Make sure the PC has the following two files:.Setup your PC with static IP on 192.168.0.0 subnet.Configure DD-WRT as desired.Īlternate Install Method using Emergency Room Web Interface Will probably have to update your IP address (if using static IP) to this subnet to be able to connect. After the flash & update is done, the router will reboot to dd-wrt, and the IP address will have changed to 192.168.1.1. (it should have finished when your browser tries to connect after the reboot, and probably fails because the IP address has changed). Wait 2 or 3 minutes for the DIR-600/DIR-300 to flash and do the update.Click 'browse' button -> select the 'dlink-revb-factory-webflash.bin' file -> click 'Upload' button.

The D-link's default login details are user 'admin', password is blank, and type the captcha from the image.

Open in your web browser, which should open the DIR600's/DIR300's administrative page from the standard D-link firmware.

Connect to the DIR-600/DIR-300 using an ethernet cable.

There will be two files, 'dlink-revb-factory-webflash.bin' and 'dir600-revb-ddwrt-webflash.bin' / 'dir300-revb-ddwrt-webflash.bin'.

Download the latest firmware from:, and enter the model as DIR600 or DIR300 as appropriate.

To install dd-wrt on either a D-Link DIR-300 Revision B1 or a D-Link DIR-600 Revision B1, you need to flash it directly from the router's web admin page (yes, that is correct. Supported by dd-wrt as of = v.24 SP2 build 12729 - 4

D link router dir 300 driver download